How do I create a 3D wire frame section in the model?


  • Create a sketch of the section lines (typically an open boundary)
  • Use the Named Section Curves command on the Wire Frame toolbar
  • Open a drawing sheet
  • Create a base view
  • Create a Section View and specify the type as 3D Named
  • Information

    Review date: 2011-May-18

    PrintPrint Get a PDF version of this webpage PDF
    © 2017 ZWCAD Software Co., Ltd. All rights reserved. | A proposito di ZWSOFT | Privacy Policy | Terms and Conditions | Contattaci | Site Map
    All trademarks, trade names or company names referenced herein are used for identification only and are the property of their respective owners.